Workgroup Contents
Lecture 10.5.2 : Design for Serviceability - II
Top
1. INTRODUCTION
2. CREEP AND SHRINKAGE
2.1 General
2.2 Creep
2.2.1 Creep: Influencing factors
2.2.2 Creep functions and creep coefficient
2.2.2.1 Definitions
2.2.2.2 Creep: Alternative formulations
2.2.2.3 Creep: Eurocode 2 formulation
2.3 Shrinkage
2.4 Methods of Analysis for Creep and Shrinkage
3. SERVICEABILITY LIMIT STATES: CRACKING
3.1 Deemed-To-Satisfy Approach
3.1.1 General
3.1.2 Minimum reinforcement areas
3.2 Explicit Calculation of Crack Widths
3.2.1 Cracking: Limit state design
3.2.2 Maximum design crack widths: limits
3.2.3 Crack width calculations
4. CONCLUDING SUMMARY
5. REFERENCES
6. ADDITIONAL READING